ISSN: 0256-1115 (print version) ISSN: 1975-7220 (electronic version)
Copyright © 2024 KICHE. All rights reserved

Articles & Issues

Language
English
Conflict of Interest
In relation to this article, we declare that there is no conflict of interest.
Publication history
Received September 3, 2001
Accepted October 15, 2001
articles This is an Open-Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/bync/3.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
Copyright © KIChE. All rights reserved.

All issues

Effect of Calcination Temperature and Addition of Silica, Zirconia, Alumina on the Photocatalytic Activity of Titania

Department of Chemical Engineering, Korea Advanced Institute of Science and Technology, 373-1, Kusong-dong Yusong-gu, Daejeon 305-701, Korea
sbpark@mail.kaist.ac.kr
Korean Journal of Chemical Engineering, November 2001, 18(6), 879-888(10), 10.1007/BF02705612
downloadDownload PDF

Abstract

Nanophase titania was prepared by sol-gel method and spray pyrolysis. We tried to elucidate the relationship between the photoactivity and the crystallite size of anatase phase. To better understand the changes in the bulk and the surface of titania as the calcination temperature is changed, EPR and photoluminescence analysis were carried out. The effect of the secondary metal oxide embedded into titania matrix on the photoactivity was also investigated. It was found that the photoactivity of titania has a linear relationship to the crystallite size. For the analysis of EPR and photoluminescence for pure titania, the increase of photoactivity with increasing the calcination temperature is due to the formation of surface active sites such as O- as well as the increase of crystallinity resulting from the removal of bulk defects. For silica/titania mixed oxide, it was found that the improvement of the thermal stability of anatase phase is important to enhance the photoactivity of titania because the prepared catalyst was calcined at a higher temperature than 700 ℃ without forming rutile phase. It was also concluded that the simultaneous increase of the surface area and the crystallinity promises to improve die photoactivity achieved by increasing the content of silica up to 60%. By the analysis of EPR and photoluminescence, it was found that the embedding of silica into titania matrix suppresses the formation of Ti3+ and produces a new active site of Ti-O-Si, which easily interacts with the oxygen. In the investigation of zirconia/titania and alumina/titania mixed oxide, it was found that the increase of the surface OH is essential to positively affect of the improved thermal stability on the photoactivity.

References

Anpo M, Aikawa N, Kubokawa Y, Che M, Louis C, Giamello E, J. Phys. Chem., 89, 5017 (1985) 
Anpo M, Nakaya H, Kodama S, Kubodawa Y, Domen K, Onishi T, J. Phys. Chem., 90, 1633 (1986) 
Anpo M, Yamada Y, Kubokawa Y, Coluccia S, Zecchina A, Che M, J. Chem. Soc.-Faraday Trans., 84, 751 (1988) 
Anpo M, Tomonari M, Fox MA, J. Phys. Chem., 93, 7300 (1989) 
Anderson C, Bard AJ, J. Phys. Chem., 99(24), 9882 (1995) 
Anderson C, Bard AJ, J. Phys. Chem. B, 101(14), 2611 (1997) 
Cauqui MA, Calvino JJ, Gifredo G, Esquivias L, Rodriquez-Izquierdo JM, J. Non-Cryst. Solids, 147-148, 758 (1992) 
Cui H, Dwight K, Soled S, Wold A, J. Solid State Chem., 115, 187 (1995) 
Do YR, Lee W, Dwight K, Wold A, J. Solid State Chem., 108, 198 (1994) 
Fu X, Clark LA, Yang Q, Anderson MA, Environ. Sci. Technol., 30, 647 (1996) 
Hoffmann MR, Martin ST, Choi WY, Bahnemann DW, Chem. Rev., 95(1), 69 (1995) 
Howe RF, Graetzel M, J. Phys. Chem., 91, 3906 (1987) 
Inoue H, Matsuyama T, Liu BJ, Sakata T, Mori H, Yoneyama H, Chem. Lett., 653 (1994) 
Kang YC, Park SB, Lenggoro IW, Okuyama K, J. Mater. Res., 16(6), 2611 (1999)
Klein S, Thorimbert S, Maier WF, J. Catal., 163(2), 476 (1996) 
Lee W, Do YR, Dwight K, Wold A, Mater. Res. Bull., 28, 1127 (1993) 
Marchese L, Maschmeyer T, Gianotti E, Coluccia S, Thomas JM, J. Phys. Chem. B, 101(44), 8836 (1997) 
Messing GL, Zhang SC, Jayanthi GV, J. Am. Ceram. Soc., 79, 2707 (1993) 
Nakaoka Y, Nosaka Y, J. Photochem. Photobiol. A-Chem., 110, 299 (1997) 
Navio JA, Colon G, Litter MI, Bianco GN, J. Mol. Catal. A-Chem., 106, 267 (1996) 
Negishi N, Fujino M, Yamashita H, Fox MA, Anpo M, Langmuir, 10(6), 1772 (1994) 
Nishimoto SI, Ohtani B, Kajiwara H, Kagiya T, J. Chem. Soc.-Faraday Trans., 81, 61 (1985) 
Ohtani B, Ogawa Y, Nishimoto S, J. Phys. Chem. B, 101(19), 3746 (1997) 
Papp J, Soled S, Dwight K, Wold A, Chem. Mater., 6, 496 (1994) 
Porter JF, Li YG, Chan CK, J. Mater. Sci., 34(7), 1523 (1999) 
Pruden AL, Ollis DF, J. Catal., 82, 404 (1983) 
Rivera AP, Tanaka K, Hisanaga T, Appl. Catal. B: Environ., 3(1), 37 (1993) 
Thangaraj A, Kumar R, Mirajkar SP, Ratnasamy P, J. Catal., 130, 1 (1991) 
Viswanath RN, Ramasamy S, Colloids Surf. A-Physicochem. Eng. Asp., 113, 49 (1998)
Yamashita H, Kawasaki S, Ichihashi Y, Takeuchi M, Harada M, Anpo M, Louis C, Che M, Korean J. Chem. Eng., 15(5), 491 (1998)
Zhang QH, Gao L, Guo JK, Appl. Catal. B: Environ., 26(3), 207 (2000) 
Zhang S, Fujii N, Nosaka Y, J. Mol. Catal. A-Chem., 129, 219 (1997)

The Korean Institute of Chemical Engineers. F5, 119, Anam-ro, Seongbuk-gu, 233 Spring Street Seoul 02856, South Korea.
TEL. No. +82-2-458-3078FAX No. +82-507-804-0669E-mail : kiche@kiche.or.kr

Copyright (C) KICHE.all rights reserved.

- Korean Journal of Chemical Engineering 상단으로