Articles & Issues
- Language
- English
- Conflict of Interest
- In relation to this article, we declare that there is no conflict of interest.
- Publication history
-
Received February 13, 2004
Accepted August 24, 2004
- This is an Open-Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/bync/3.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
Copyright © KIChE. All rights reserved.
All issues
Behavior of Amino Acid Production from Hydrothermal Treatment of Fish-Derived Wastes
Institute of Seafood Science, Faculty of Food Science & Biotechnology, Pukyung National University, Busan 608-737, Korea
bschun@pknu.ac.kr
Korean Journal of Chemical Engineering, November 2004, 21(6), 1147-1152(6), 10.1007/BF02719486
Download PDF
Abstract
The effect of operating parameters (temperature and time) and various reaction modes(batch, semi-batch and continuous flow) on the behavior of amino acid production from hydrothermal decomposition of fish-derived wastes was investigated. The amino acids obtained in batch experiments at 523 K were mainly alanine (Ala) and glycine (Gly) at maximum yield of 65 and 28 mg/g-dry fish, respectively. At a relatively lower temperature of 473 K, the relative concentration of high-molecular-weight amino acids such as aspartic acid (Asp) and serine (Ser) is significantly high, but decreases as temperature increases. It is likely that high-molecular-weight amino acids decompose faster than low-molecular ones. Semi-batch and continuous flow modes of reaction suppressed decomposition of amino acids into organic acids (or volatile materials) by continuously removing the products from the reaction zone as soon as they were formed. Thus, a large amount of high-molecular-weight amino acids such as Asp and Ser at these reaction modes was observed. This increases the yield of total amino acids at short reaction time and at temperature relatively higher than 523 K. It was also observed that the composition of the resulting products also depends on the modes of reaction.
References
Adschiri T, Sato O, Machida K, Saito N, Arai K, Kag. Kog. Ronbunshu, 23(4), 505 (1997)
Daimon H, Kang K, Sato N, Fujie K, J. Chem. Eng. Jpn., 34(9), 1091 (2001)
Goto M, Nada T, Kodama A, Hirose T, Ind. Eng. Chem. Res., 38(5), 1863 (1999)
Kang K, Quitain AT, Daimon H, Noda R, Goto N, Hu H, Fujie K, Can. J. Chem. Eng., 65, 79 (2001)
Kang KY, Quitain AT, Urano S, Daimon H, Fujie K, Ind. Eng. Chem. Res., 40(16), 3717 (2001)
Kang KY, Chun BS, Korean J. Chem. Eng., 21(3), 654 (2004)
Kim YJ, Hong WH, Wozny G, Korean J. Chem. Eng., 19(5), 808 (2002)
Meyer JC, Marrone PA, Tester JW, AIChE J., 41(9), 2108 (1995)
Kim YJ, Hong WH, Wozny G, Korean J. Chem. Eng., 19(5), 808 (2002)
Sasaki M, Kabyemela B, Malaluan R, Hirose S, Takeda N, Adschiri T, Arai K, J. Supercrit. Fluids, 13(1), 261 (1998)
Savage PE, Chem. Rev., 99(2), 603 (1999)
Seo Y, Hong WH, Hong TH, Korean J. Chem. Eng., 16(5), 556 (1999)
Shanableh A, Water Res., 34, 945 (2000)
Shaw RW, Brill TB, Clifford AA, Eckert CA, Franck EU, Chem. Eng. News, 12, 26 (1991)
Yoshida H, Terashima M, Takahashi Y, Kag. Kog. Ronbunshu, 50, 57 (1999)
Daimon H, Kang K, Sato N, Fujie K, J. Chem. Eng. Jpn., 34(9), 1091 (2001)
Goto M, Nada T, Kodama A, Hirose T, Ind. Eng. Chem. Res., 38(5), 1863 (1999)
Kang K, Quitain AT, Daimon H, Noda R, Goto N, Hu H, Fujie K, Can. J. Chem. Eng., 65, 79 (2001)
Kang KY, Quitain AT, Urano S, Daimon H, Fujie K, Ind. Eng. Chem. Res., 40(16), 3717 (2001)
Kang KY, Chun BS, Korean J. Chem. Eng., 21(3), 654 (2004)
Kim YJ, Hong WH, Wozny G, Korean J. Chem. Eng., 19(5), 808 (2002)
Meyer JC, Marrone PA, Tester JW, AIChE J., 41(9), 2108 (1995)
Kim YJ, Hong WH, Wozny G, Korean J. Chem. Eng., 19(5), 808 (2002)
Sasaki M, Kabyemela B, Malaluan R, Hirose S, Takeda N, Adschiri T, Arai K, J. Supercrit. Fluids, 13(1), 261 (1998)
Savage PE, Chem. Rev., 99(2), 603 (1999)
Seo Y, Hong WH, Hong TH, Korean J. Chem. Eng., 16(5), 556 (1999)
Shanableh A, Water Res., 34, 945 (2000)
Shaw RW, Brill TB, Clifford AA, Eckert CA, Franck EU, Chem. Eng. News, 12, 26 (1991)
Yoshida H, Terashima M, Takahashi Y, Kag. Kog. Ronbunshu, 50, 57 (1999)