Articles & Issues
- Language
- English
- Conflict of Interest
- In relation to this article, we declare that there is no conflict of interest.
- Publication history
-
Received July 13, 2012
Accepted November 26, 2012
- This is an Open-Access article distributed under the terms of the Creative Commons Attribution Non-Commercial License (http://creativecommons.org/licenses/bync/3.0) which permits unrestricted non-commercial use, distribution, and reproduction in any medium, provided the original work is properly cited.
Copyright © KIChE. All rights reserved.
All issues
Evaluation of the performance of a commercial circulating fluidized bed boiler by using IEA-CFBC model: Effect of primary to secondary air ratio
Green Energy Laboratory, Korea Electric Power Corporation (KEPCO) Research Institute, Daejeon 305-380, Korea
jmlee@kepri.re.kr
Korean Journal of Chemical Engineering, May 2013, 30(5), 1058-1066(9), 10.1007/s11814-012-0206-x
Download PDF
Abstract
The performance of a commercial circulating fluidized bed boiler in the Yeosu thermal power plant, which has been operating since October 2011 by KOSEP, has been evaluated by using the IEA-CFBC model. To validate the calculation procedure of the model, the calculated results were compared with the operation values such as the temperatures, pressures, emissions of SO2 and NO, particles size distribution and unburned carbon fraction of the CFB boiler at a certain actual condition. The calculated results were comparable to measured values from the CFB boiler, so these could conform to acceptable formats with a good accuracy. The effect of the primary to secondary air ratio on the performance of the CFB boiler was also determined. As the primary air ratio increased, the solid fraction and temperature in the furnace freeboard increased. As a result, the solid circulation rate and the heat absorption in the furnace increased with increasing the PA ratio. In the case of the amount of heat absorption, the wall tube of the furnace absorbed much more generation heat in the furnace than the wing wall tube. The SO2 emission decreased due to increase of the limestone hold up in the furnace, and the combustion efficiency somewhat increased with increasing the PA ratio. Therefore, from these results, we could expect to control the boiler performance such as the furnace temperature, steam temperatures of superheater or reheater, gaseous emissions and combustion efficiency through the changing the PA ratio of the CFB boiler.
References
Leckner B, Therm. Sci., 11, 5 (2007)
Koornneef J, Junginger M, Faaij A, Progress in Energy Combus. Sci., 33, 19 (2007)
Leckner B, Developments in fluidized bed conversion during 2005-2010, IEA-FBC Report, Chalmers University of Technology Press, Sweden (2011)
Zhan M, Wu H, Sun Y, Lu Q, 21st International Conference on Fluidized Bed Combustion, Naples, Italy, 107 (2012)
Utt J, Giglio R, Power-Gen India & Central Asia Conference, New Delhi, India, 3 (2012)
Nowak W, Walkowiak R, Ozimowski T, Jablonski J, Wyszynski J, 9th International Conference on Circulating Fluidized Beds, Hamburg, Germany, 1057 (2008)
Jantti T, Parkkonen R, Power Gen Asia, Bangkok, Thailand (2009)
Park HJ, Jung NH, Lee JM, Korean J. Chem. Eng., 28(8), 1791 (2011)
Kim DW, Lee JM, Park KI, Lee TH, Kim JS, Proceedings of 2012 KIChE Spring Meeting., 311 (2012)
Pritchett JW, Blake TR, Garg SK, AIChE Symp. Ser., 74, 134 (1978)
Boemer A, Qi H, Renz U, Proceedings of the 29th IEA-FBC Meeting, Paris, France (1994)
Pallares D, Palonen M, Yla-Outinen V, Johnsson F, Proceedings of the 21th International Conference on FBC, Naples, Italy, 867 (2012)
Mori S, Narukawa K, Yamada I, Takebayashi T, Tanii H, Tomoyasu Y, Mii T, Proceedings of the 11th International Conference on FBC, Montreal, Canada, 1261 (1991)
Zhang L, Li TD, Zhen QY, Lu CD, Proceedings of the 11th International Conference on FBC, Montreal, Canada, 1289 (1991)
Hannes JP, Mathematical modeling of circulating fluidized bed combustion, PhD Thesis, Delft University of Technology, The Netherlands (1996)
Lee JM, Kim JS, Korean J. Chem. Eng., 16(5), 640 (1999)
Lee JM, Kim JS, Kim JJ, Energy, 28(6), 575 (2003)
Wen YC, Chen LH, AIChE J., 6, 117 (1982)
Wirth KE, Chem. Eng. Technol., 11, 11 (1988)
Hannes JP, Bleek CM, Renz U, Proceedings of the 13th International Conference on Fluidized Bed Combustion, Orlando, Florida, 287 (1995)
Lee JM, Kim JS, Korean Chem. Eng. Res., 38(1), 53 (2000)
Ergun S, Chem. Eng. Prog., 48, 89 (1952)
Merrick D, Highley J, AIChE Symp. Ser., 70(137), 366 (1974)
Bellgardt D, Hembach F, Schoessler M, Werther J, Proceedings of the 9th International Conference on FBC, Boston, 713 (1987)
Smith IW, Fuel., 57, 409 (1978)
Wolff EHP, Regenerative sulfur capture in fluidized bed combustion of coal, PhD Thesis, Delft University of Technology, The Netherlands (1991)
Kunii D, Levenspiel O, Fluidization Engineering 2nd Ed., Butterworth-Heinemann (1991)
Seiter M, Radial solid concentration and axial solid concentration in near wall areas circulating fluidized bed, PhD Thesis, Erlangen, Germany (1990)
Brereton CMH, Grace JR, Chem. Eng. Sci., 48, 2565 (1993)
Glatzer A, Solid distribution and heat transfer by radiation in circulating fluidized bed, PhD Thesis, Vienna University, Austria (1994)
Lee JM, Kim DW, Kim JS, Operation analysis and guide for the Yeosu CFB boiler, Technical Report (TM K02P2011), KEPRI, Korea (2011)
Gottung EJ, Darling SL, Proceedings of the 10th International Conference on FBC, New York, 617 (1989)
Basu P, Combustion and gasification in fluidized beds, CRC Press, Taylor & Francis Group, New York (2006)
Koornneef J, Junginger M, Faaij A, Progress in Energy Combus. Sci., 33, 19 (2007)
Leckner B, Developments in fluidized bed conversion during 2005-2010, IEA-FBC Report, Chalmers University of Technology Press, Sweden (2011)
Zhan M, Wu H, Sun Y, Lu Q, 21st International Conference on Fluidized Bed Combustion, Naples, Italy, 107 (2012)
Utt J, Giglio R, Power-Gen India & Central Asia Conference, New Delhi, India, 3 (2012)
Nowak W, Walkowiak R, Ozimowski T, Jablonski J, Wyszynski J, 9th International Conference on Circulating Fluidized Beds, Hamburg, Germany, 1057 (2008)
Jantti T, Parkkonen R, Power Gen Asia, Bangkok, Thailand (2009)
Park HJ, Jung NH, Lee JM, Korean J. Chem. Eng., 28(8), 1791 (2011)
Kim DW, Lee JM, Park KI, Lee TH, Kim JS, Proceedings of 2012 KIChE Spring Meeting., 311 (2012)
Pritchett JW, Blake TR, Garg SK, AIChE Symp. Ser., 74, 134 (1978)
Boemer A, Qi H, Renz U, Proceedings of the 29th IEA-FBC Meeting, Paris, France (1994)
Pallares D, Palonen M, Yla-Outinen V, Johnsson F, Proceedings of the 21th International Conference on FBC, Naples, Italy, 867 (2012)
Mori S, Narukawa K, Yamada I, Takebayashi T, Tanii H, Tomoyasu Y, Mii T, Proceedings of the 11th International Conference on FBC, Montreal, Canada, 1261 (1991)
Zhang L, Li TD, Zhen QY, Lu CD, Proceedings of the 11th International Conference on FBC, Montreal, Canada, 1289 (1991)
Hannes JP, Mathematical modeling of circulating fluidized bed combustion, PhD Thesis, Delft University of Technology, The Netherlands (1996)
Lee JM, Kim JS, Korean J. Chem. Eng., 16(5), 640 (1999)
Lee JM, Kim JS, Kim JJ, Energy, 28(6), 575 (2003)
Wen YC, Chen LH, AIChE J., 6, 117 (1982)
Wirth KE, Chem. Eng. Technol., 11, 11 (1988)
Hannes JP, Bleek CM, Renz U, Proceedings of the 13th International Conference on Fluidized Bed Combustion, Orlando, Florida, 287 (1995)
Lee JM, Kim JS, Korean Chem. Eng. Res., 38(1), 53 (2000)
Ergun S, Chem. Eng. Prog., 48, 89 (1952)
Merrick D, Highley J, AIChE Symp. Ser., 70(137), 366 (1974)
Bellgardt D, Hembach F, Schoessler M, Werther J, Proceedings of the 9th International Conference on FBC, Boston, 713 (1987)
Smith IW, Fuel., 57, 409 (1978)
Wolff EHP, Regenerative sulfur capture in fluidized bed combustion of coal, PhD Thesis, Delft University of Technology, The Netherlands (1991)
Kunii D, Levenspiel O, Fluidization Engineering 2nd Ed., Butterworth-Heinemann (1991)
Seiter M, Radial solid concentration and axial solid concentration in near wall areas circulating fluidized bed, PhD Thesis, Erlangen, Germany (1990)
Brereton CMH, Grace JR, Chem. Eng. Sci., 48, 2565 (1993)
Glatzer A, Solid distribution and heat transfer by radiation in circulating fluidized bed, PhD Thesis, Vienna University, Austria (1994)
Lee JM, Kim DW, Kim JS, Operation analysis and guide for the Yeosu CFB boiler, Technical Report (TM K02P2011), KEPRI, Korea (2011)
Gottung EJ, Darling SL, Proceedings of the 10th International Conference on FBC, New York, 617 (1989)
Basu P, Combustion and gasification in fluidized beds, CRC Press, Taylor & Francis Group, New York (2006)